Showing posts with label solder enameled copper wire. Show all posts
Showing posts with label solder enameled copper wire. Show all posts

2015/11/06

Self-Bonding magnet wire

Ultra Fine Self-Bonding Rectangular Enameled Copper Wire is suitable to lifting electromagnets, reactors and other low-voltages and high current electromagnetic windings.

We have a big variety of self bonding wire types available.

Different base coats and self bonding overcoats are described in different standards, such as NEMA MW 1000 or JIS C 3202, IEC 60317, which will use different test methods in sometimes .

The different base coats have the different typical technical values ,such as Polyurethane, Polyester, Polyesterimide etc.


Besides, it also has different bond coats, such as Polyvinylbutyral, Polyamide etc. According to different products' uses, we present different product recommendations,including diameter, temperature and insulation materials.


2014/10/14

How to solder enameled copper wire?

1.Set out all your parts to solder. Why we do this? Because the soldering iron is extremely hot, don't lay it down while you are looking for the next part to solder. You can buy a soldering kit, which includes a soldering gun and base, sponge and solder. Or you may already have some components such as the soldering iron. Put on all protective gear.

2.Plug in the soldering iron. Place the soldering iron in the stand. The soldering iron will take a few minutes to heat up. Only heat it up when you are ready to go. This prevents accidental burns or fires. Get your sponge wet and then wring out the water. The idea is to have a damp sponge, not one soaking in water.

3.Check the manufacture's instructions for the appropriate wattage for your specific electronics project. Electronic components require a certain amount of heat. Too much heat can melt the part you're trying to solder. Soldering irons come in different wattage outputs, so check for proper wattage rating.

4.Apply the tip of the soldering iron to the wet sponge to make the tip clean. Cleanliness is a must for good solder joints. Hold the soldering iron to the part you are soldering. Think of holding a pen or pencil. Avoid any contact with the tip or heat shield; both can reach 400 degrees in temperature.

5.Hold the solder to the joint you are trying to solder. Place the tip of the solder at the point where the solder iron tip and part you are soldering meet. Hold the solder in place for a few seconds until solder starts to flow. Remove the soldering iron before you apply too much heat. Inspect your joint. The joint should look like a dome and be shiny. It not, then apply a bit more solder to build up the joint. Don't forget to clean your soldering iron often on the wet sponge.
Established in 1993, has developed a professional manufacturer of Magnet Wires in China.